Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY (CONTINUED)
Tightening
3. The Main Table Top (photo D) is then
Lever
fitted on to the Side Table Top (photo E).
When fitted it as par Photo F.
4. Make sure the tightening lever (photo
G) and height adjustment knob (photo
H) are tight so that the Main Table Top
F
will not tilt and the table top will not slip
Plate
downwards
USAGE
The table can be used in several ways.
First of all it can be used as Photo A. The Main Table Top can then be tilted as per Photo G - this is done
by undoing the tightening nut, then tilting the Main Table Top to the required tilt and then retightening
the nut.
The Main Table Top can also be extended sideways again by loosening the tightening nut, then extending
the table and re tightening the nut (photo H). If the table is extended please make sure it is safe to do
so in the particular circumstances (risk assessment) but would recommend that the table width of the
whole unit should not exceed 1 metre.
NB. Please make sure the tightening nut is tight so that the Main Table Top will not tilt from its set
position. The Side Table Top will not tilt and is therefore better
suited for hot drinks etc so as to avoid spilling/scalding.
HEIGHT ADJUSTMENT
The height of the table can be adjusted by first
loosening the height adjustment knob and then
selecting the required height. Re tighten the height
G
adjustment knob making sure it is tight enough so that
the table will not slip downwards. It is recommended
that the maximum height of the table is 1 metre.
A
H
3
Fixing and Maintenance Instructions
Publicité
Table des Matières
