Before Use - aidapt VG832A Instructions De Fixation Et D'entretien

NB. This equipment must be installed by a competent person.
VG832A Self Assembly with castors
Do not exceed the weight limit on the table as this could damage the equipment or put the
user at risk. Exceeding the weight limit may also cause the table to tilt.
Do not lean on the table or use it as a support aid when rising from a chair or bed.
If the table is to be used with hot items (eg hot drink) then a risk assessment is advised as
to scalding etc. because part of the table can tilt.

BEFORE USE

Carefully remove all packaging and avoid using knives or other sharp instruments as this may damage
the surface of the equipment. Check the product for any visible damage and if you see any damage or
suspect a fault do not use the equipment and contact your supplier.
ASSEMBLY
1. Attach top of Column
(photo C) to the 'plate'on
the side table top (photo E)
using 4 x nut, bolt and washer.
The nuts are 'nylocs' and are a
safety device to stop the nut and
bolt on screwing. The nuts and
bolts need to be fully tightened
using the spanner and alan key
and the nyloc will give resistance
all the way until it is fully tightened.
The nuts are on the inside of the
plate with the bolt head showing
on the outside of the plate.
2. Attach the Base (photo B) to the
bottom of the Column (photo C)
using 1 x bolt and Ix nut, bolt and
washer (again nyloc) making sure
completely tightened.
Fixing and Maintenance Instructions
E
CONTENTS
1 x Base (photo B)
1 x Column (photo C)
1 x Main Table Top (photo D)
1 x Side table Top (photo E)
C
1 x Bag of nuts and bolts -
4 x nut, bolt and washer
1 x nut, bolt and washer 1 x bolt
1 x spanner
1 x allen key
B
2
Weight Limit: 20kg
D
.._