Astralpool 45862 Manuel D'installation Et Entretien page 6

PROGRAMMING THE DIGITAL TIMER
The programming of the digital timer is divided into 4 different stages: Season, day, time and programmed speed.
The programming process is shown in the following diagram:
Start screen
PROG /OK (over 3 seconds)
Programming: Season
Selection: DAY/SEASON (over 3 seconds)
Continue programming: PROG/OK
Programming: Day of week
Selection: DAY/SEASON
Continue programming: PROG/OK
Programming: Time
Selección: TIME
Continue programming: PROG/OK
Programming: Speed
Selection: STOP/ECO/TURBO
Continue programming: PROG/OK (next time)
To enter programming mode, the PROG/OK button should be pressed for 3 seconds. We enter the season selection screen.
On all the screens, the PROG/OK button should be pressed briefly to confirm. To leave the programming mode, the
PROG/OK button should be pressed down for 3 seconds or more.
CLEARING PROGRAMMES
The digital timer allows programmes to be deleted by whole days.
To delete a whole day, the ERASE button should be pressed down for 5 seconds on the Time or Speed programming screen.
SPECIAL PROGRAMMES: RINSE AND BACKWASH
The digital timer has two specific programmes for the maintenance of the filter: RINSE and BACKWASH.
To access these programmes, the digital timer should be in manual mode. The process will therefore be as follows:
1: Access manual mode: Press the MAN/AUTO button until reaching the MAN mode (see screen).
2: Press the RINSE or BACKWASH button activate the programme.
To stop the functioning of the programme, it is sufficient to press the ERASE button at any time.
PROGRAMMING OF THE SPECIAL PROGRAMMES
To programme any of the two programmes for the maintenance of the filter, the process described below should be followed:
Programming RINSE:
Start screen
PROG /OK + RINSE
The words PROG and RINSE blink
STOP/ECO/TURBO
Selecting speed (Eco or Turbo)
Factory values: TURBO mode for 30 seconds
6
Exit: PROG /OK (over 3 seconds)
Exit: PROG /OK (over 3 seconds)
Exit: PROG /OK (over 3 seconds)
Delete day: ERASE (over 5 seconds)
Exit: PROG /OK (over 3 seconds)
Delete day: ERASE (over 5 seconds)
Selecting time (sec.)
To confirm: PROG/OK
Start screen
Electrical cabinet Dual-Speed pump
TIME