HP DesignJet T1200 Serie Informations D'introduction page 5

Message or code
61:01
62, 63, 64, 65, 67
71.04
74.1
79:03
79:04
81:01, 86:01
94, 94.1
Recommendation
The file format is wrong and the printer cannot process the job. Check the
graphic language setting of your printer. If you are sending PostScript from
Mac OS over a USB connection, select ASCII encoding in both the driver and
the application. Check for the latest firmware and driver releases.
Update your printer's firmware.
Out of memory. To avoid this, in the HP-GL/2 and HP RTL driver select the
Advanced tab and then
Try the firmware update again. Do not try to use your computer while the
update is in progress. If the problem persists, contact HP Support.
Restart the printer. If the problem persists, contact HP Support.
Update your printer's firmware.
Please follow the instructions on the front panel. You may be asked to run a
test procedure and write down a numeric code before contacting HP Support.
Restart color calibration.
Send job as a bitmap.
Introductory Information 4