Circadiance SmartMonitor 2 Guide Des Parents page 49

•
The home care dealer should now call to retrieve the information. The phone may ring, but do not answer. The
modem answers the call and connects the SmartMonitor 2 to the computer through the phone line.
3. The amount of time to transfer the information will vary. When the transfer is complete the SmartMonitor 2 will beep 5
times. After the transfer, you may disconnect the phone line from the monitor and the phone will work normally. Turn the
monitor off in the normal way.
•
Press and hold the blue RESET button.
•
Press and release the gray POWER button.
•
Wait 2 seconds, and then release the RESET button.
•
You may now reconnect the baby and resume monitoring.
Modem Auto Answer in Monitor Mode
1. Connect the phone cord from the wall jack to the modem connector on the back of the SmartMonitor 2.
If there is an emergency and access to the telephone is required while modem is in use remove phone
cord from modem slot and use a working phone.
2. To allow the SmartMonitor 2 to work with the modem when the monitor is in monitor mode (the baby is being monitored):
•
When the home care dealer calls for a download and the phone rings, you should press and hold down the blue
RESET button.
•
Hold down the RESET button until the phone stops ringing indicating the monitor has answered the call.
•
The amount of time to transfer the information will vary. When the transfer is complete the SmartMonitor 2 will beep 5
times.
•
After the transfer, disconnect the phone line from the monitor and the phone will work normally.
Be aware that some features available on your phone may interfere with the download: Call Waiting, Call Forwarding,
and Party Lines all increase the likelihood of problems when downloading. Call Waiting cannot be disabled when
receiving a phone call.
Transferring SmartMonitor Information
43