Circadiance SmartMonitor 2 Guide Des Parents page 36

If this light And this condition exists
is on
Loose Lead Continuous yellow light and no alarm
Continuous green light, continuous
Power
alarm, with no other lights lit.
All All lights are blinking and the alarm
sounds for 3 seconds and then off for 1
second.
It means...
If you correct the problem, the alarm will stop. However, the
yellow light remains on until you press the RESET button.
Check the display for error messages.
If no error messages, the SmartMonitor 2 was turned off
improperly causing a sibling alarm.
To resolve:
Press and hold the blue RESET button.
Press and release the gray POWER button.
Wait 2 seconds then release the RESET button.
Check the display for error messages. If there is an error
message, enter it in on your log sheet.
Turn the monitor off and then back on. If the monitor functions
normally continue to use the monitor.
Responding to Alarms
30