Device Description; Initial Commissioning; Interfaces - Bosch DCU 220 Consignes D'utilisation

3.4

Device description

The docking station replicates most ports of the
DCU 220 and provides additional ports.
By connecting peripheral devices such as keyboard,
mouse, monitor or printer, the docking station can
turned into a handy work station for the desktop.
Fig. 1: Front view
1 Lock
2 Guide pin
3 Guide pin
4 Guide pin
5 Docking connection
6 Guide pin
7 Power LED
3.4.1

Interfaces

Fig. 2: 1 687 023 911 Rear view
1 Serial interface RS232 (2 x)
2 Microphone port
3 Headphone port
4 VGA port
5 USB 3.0 port
6 USB 2.0 port (3 x)
7 RJ-45 port (LAN)
8 Mains port
Fig. 3: 1 687 023 911 Right side
1 Lock
Fig. 4: Left side of 1 687 023 911
1 Connection for a Kensington lock
Robert Bosch GmbH

Initial commissioning | 1 687 023 911 | 11 |

4. Initial commissioning
4.1 Adapter plate (special accessory)
i
The adapter plate is required to secure the docking
station to a trolley.
4.1.1 Installing on docking station
1. Remove the four screws.
2. Align the holes and secure the adapter plate to the
docking station using the four screws previously
removed.
4.1.2 Installing on trolley
1. Secure the right-hand and left-hand slide to the top
bores of the trolley using two screws.
2. Align the slides so that they are fixed in the
recesses in the trolley.
i
On the underside of the adapter plate there is a rail
with two holes for the slides.
en
|
1 689 989 322 2021-01-24