Hinkley 930001 Instructions D'installation page 3

INSTALLING THE LIGHT KIT
WARNING: Be sure electricity is turned off at the main power box
before wiring.
Remove and discard the center plug from the switch
1
housing. Attach the light kit to the switch housing by feeding
the light fixture wires (black and white) through the hole in
the center of the switch housing, then screw the light fixture
stem onto the switch housing. (Fig. 1)
Thread the nut & lock washer onto the light fixture stem
2
inside the switch housing making sure the light fixture is
secure, preventing movement after installation. (Fig. 1)
Locate the white and blue wires inside the switch housing
3
labeled FOR LIGHT.
Attach the wires from the light kit to the wires inside the
4
switch housing by pushing the polarized connections
together. (Fig. 1)
- White wire to White wire
- Black wire to Black (Blue) wire
Raise and hold the light kit assembly close to the switch
5
housing hub of the ceiling fan. Push the square wire
connectors together. (Fig. 2)
NOTE: The square connectors are color coded. Match the
color coded sides of each plug and push. They will attach
ONLY when matched correctly.
Carefully push all wires back into the switch housing, then
6
install the light kit assembly onto the switch housing hub
with 3 screws provided. Be sure to tighten all screws. (Fig. 2)
Mount the plastic shade to the light sockets by unscrewing
7
partway the three light holder set screws on glass holder.
Insert the glass shade, then gently tighten the set screws by
hand evenly to the plastic shade. Do not overtighten.
Nut
Lock Washer
Center
Plug
Fig. 1
Keyhole Slot (x3)
Connector (receptacle)
Set Screws
Glass
Shade
Fig. 2
©2019 Hinkley Lighting, Inc. | hinkley.com |
Switch
Housing
Light Kit
Switch Housing Hub
(bottom of motor)
Connector (plug)
with Side Buckle
Light Kit
Assembly
Pull Chain
03