Troubleshooting - Schneider Airsystems SSP-SAV Notice D'utilisation D'origine

GB
SSP
2.9

Troubleshooting

Observe the safety instructions and maintenance instructions!
Problem
A No material or
insufficient mate-
rial sprayed
*For troubleshooting: refer to the information in the "Technical data" chapter in part 1 of the instruction manual!
**See Chapter: "Intended use" in Instruction manual part 1!
***For troubleshooting: read chapter: "Commissioning"!
****For troubleshooting: read chapter: "Maintenance"!
If necessary, contact our service staff, see last page.
II/ 10
Cause
Nozzle (item 11) blocked
Nozzle (item 11) not adjusted
or setting incorrect
Nozzle (item 11) or Venturi
nozzle worn
Ventilation (item 15) on blast-
ing abrasive vessel blocked
Air pipe (item 07) on material
suction hose blocked
Moist air
Blasting abrasive too coarse
Hose diameter too small
Compressor output too small
Working pressure (flow pres-
sure) too low
Remedy
X
Clean nozzle dry or replace
***
X
Adjust nozzle
X
Replace nozzles
Schneider Druckluft GmbH or
your local service partner.
X
Clean ventilation dry or replace
****
cover
X Clean air pipe dry or replace
X Install a water separator or com-
pressed air dryer
X
Use blasting abrasive with a
maximum grain size of 0.8 mm
X Use correct hose diameter
X Use different output
*
rating
X
Increase working pressure (flow
pressure) Observe
working pressure
or contact
*
*
maximum
*