Heath Zenith 6180 Serie Manuel D'instructions page 4

®
Your Heath /Zenith wireless chime has different selectable tunes: Ding (one
note), Ding-Dong (two note), or Westminster (eight note) (Available on se-
®
lected Heath /Zenith chimes). The factory setting is for the Ding-Dong tune
(or Westminster, when available). This tune can be changed by following the
instructions below.
• Ding (one note tune)
Push Button: Add a jumper to location 8.
• Ding-Dong (two note tune)
Push Button: Remove jumper from location 8.
Chime: Remove jumper from location 8.
• Westminster (Eight note tune) (Available on selected Heath
Push Button: Remove jumper from location 8.
Chime: Add a jumper to location 8.
Note: All models have both front and back door tune capabilities. You may
purchase any Heath
recommend the back door use the Ding tune and the front door use the
Ding-Dong tune (or Westminster tune, available on selected Heath
chimes). Models that include two push buttons will come factory set for front
and back doors. Decals on the rear of the push button will indicate its setting.
Inside Chime
Tune Setting
(Not used on
Tune Settings
®
/Zenith wireless push button for a second entrance. We
all models)
Note: Some models might require the use of
tweezers to remove and replace the jumpers.
Push Button Battery Replacement
Install an alkaline type A23 12 Volt bat-
tery. See diagram inside push button for
correct battery orientation.
Inside Push
Button
-4-
®
/Zenith chimes)
* Code Settings 1-7
Must Match Both
Push Button and
Chime
Tune
Setting
595-5506-08
®
/Zenith