GAMCO DR-510 Installation page 2

Description
Gamco warm air hand dryer is powered by a universal brush motor. This small, low profile, ADA compliant hand dryer is multi-voltage
running on 110 up to 240 Volt AC electrical supply. Operation is automatically controlled on/off, by an infrared sensor. This appliance is
intended for use in hand drying, contributing to hygienic and cost effective hand sanitation in small business, office and light to medium
duty environments.
General Specifications
Models Nozzle Drying Cycle
DR-510 Integral Automatic
Electrical Specifications
Models Type
DR-510 Automatic
DR-510 Automatic
(*) This hand dryer is a multi-voltage appliance that will self adjust to the available supply from 110 up to 240 VAC.
(**) As measured, Root Mean Square (RMS)
General Safety Information
DANGER
• Always disconnect the power source before servicing or installing the hand dryer.
DANGER
• This hand dryer must be properly grounded (Earthed) for safe operation. An identified ground connection point is supplied on the
hand dryer's wall base.
• We recommend GFCI protection in wet or damp locations or as required by local code.
WARNING
• Use only the electrical power (voltage and frequency) specified for the model hand dryer being installed.
• Connect the hand dryer to the nearest suitable distribution panel.
• To limit a voltage drop, and insure efficient operation, use wire gauge as required by local or National Electrical Code.
• Do not connect to a branch circuit with CB or fuse protection over 15 Amps. This is in compliance with The National Electrical Code.
• All automatic model hand dryers must have a dedicated 15 Amp circuit as required by Underwriters Laboratories, Inc. (UL).
• Route all field wiring away from any moving parts within the hand dryer.
CAUTION
Unpacking
1. Remove all packing material. Recycling is recommended.
2. Carefully remove the hand dryer from the shipping carton, using care not to drop the appliance.
3. Inspect carefully for any damage that may have occurred during transit. Check for any loose, missing or damaged parts. If the hand
dryer is damaged, promptly inform the shipper or dealer where you purchased it.
Form No. DR-510
68-10217 rev01
Dimensions (WxDxH)
9" x 9-3/4" x 4"
Electrical Input *
110-120 VAC, 50/60 Hz
208-240 VAC, 50/60 Hz
Failure to disconnect the power source before installation can result in serious injury
or death from electric shock.
Failure to properly ground this unit could result in severe electrical shock and/or
death.
Risk of fire, personal injury or property damage are possible if local codes, NEC
codes or safety recommendations are not followed.
Improper mounting could result in personal injury or property damage.
Multi Language (Rev. 10/1/13)
Amperage **
8
7
© 2013 Gamco Commercial Restroom Accessories, A Division of Bobrick
2
Weight
6.5 lbs
Watts
1000
cULus Listed E43125
1700
Cover Material
Aluminum
Printed in U.S.A.