Klarfit Pacemaker X1 Mode D'emploi page 23

1 Plug the power plug into the mains socket.
2 Place the magnetic key on the contact surface on the control panel.
3 Press the power button to turn on the computer. The latter then carries
out a short test.
4 Press the (+) button repeatedly to slowly increase the speed of the
treadmill to a comfortable walking pace.
5 Press the mode button to switch between the 5 different display modes:
scan, speed, time, distance and calories burnt. With the scan function, the
display changes automatically every 5 seconds.
6 Reduce the speed step by step by pressing (-) until it stops or remove the
magnetic key from the contact surface.
Note: After 4 minutes without use, the display switches off automatically.
TROUBLESHOOTING
Computer not working properly
In this case, check that the computer's connection cables are properly
connected. Also make sure that the magnet switch still works and that the
magnet key is correctly attached.
EN
23