Klarfit Pacemaker X1 Mode D'emploi page 19

ASSEMBLY
Step 1
Open the packaging and remove the
contents. Make sure that none of the
following parts are missing:
• 1 x treadmill main frame
• 2 x handle supports
• 1 x handle
• 1 x key bag
Step 2
Secure both handle supports to the main
frame with bolts and washers. Then take the
screw knobs and washers, pass each screw
knob through the brackets on the handle
support and tighten them (picture 1). Then
connect the computer cables as shown in
Figure 2.
Step 3
Take the handle and place it on the handle
supports (as shown in the picture). Secure
it with screws and curved washers. Then
connect the computer cables as shown in
Figure 3.
Figure 3
EN
Key
Figure 1
Figure 2
19