ATH-Heinl Frame Lift 30FZ Manuel D'utilisation page 52

1. Preparation
a. Carefully read all safety instructions before operating the lift.
b. Completely lower the lift.
c. Position the vehicle centrally between the scissors, paying attention to the load distribution.
d. Place the rubber plate CENTRALLY under the original lifting points of the vehicle.
2. Lifting
a. Switch on the lift with the main switch
b. Lift the vehicle to a height of 100-150mm and stop lifting by releasing the lift button.
c. Check that the vehicle is safely on the lift.
d. Continue lifting and watch the lifting process.
3. Lowering
a. Before lowering, check for any objects under the vehicle.
b. Press the lower button.
c. When the CE stop is reached, the lower button must be released and then pressed again.
4. Finishing
a. Completely lower the platform.
b. Remove the rubber plate.
c. Drive the vehicle off the lifting platform.
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2021-09
Manufacturer ATH-Heinl GmbH & CO.KG
- 7 -