Publicité
Bounce
HID/PicoEmitter
®
1.
Remove electronic driver cover from
fixture.
4.
Install driver housing cover and tighten
securely.
7. Remove (2) front screws securing
reflector assembly to fixture hood and
lift free of lower locating pins.
Allow it to rest on the lens frame
assembly.
• 17760 Rowland Street • City of Industry, CA 91748 • 626-968-5666
© 2021 KIM LIGHTING
TIR Upgrade Kit Installation Instructions
™
2. Grab handle and remove HID ballast
assembly from the housing.
5. Depress latch on outer edge of the
lens frame to release the fixture hood.
8. Disconnect reflector assembly quick dis-
connect from fixture quick-disconnect.
Remove from fixture.
3.
Align and slide upgrade driver
assembly into the housing.
6. Push hood assembly up until the
stop arm snaps into the retention
bracket.
9. Place Optical Array on lens frame
assembly. Connect LED quick-
disconnect to fixture quick-disconnect.
Page 2
Publicité
