kim lighting BNS1-LED Instructions D'installation

17760 Rowland St.
City of Industry, CA 91748
626/968-5666
Bounce HID/PicoEmitter
®
WARNING: Fixtures must be grounded in accordance with local codes or the National Electrical
!
Code. Failure to do so may result in serious personal injury.
WARNING: RISK OF FIRE OR ELECTRICAL SHOCK. install this kit only in the luminaires that
!
have the construction features and dimensions shown in the photographs and/or drawings.
luminaires wiring, power supply, or other electrical parts may be damaged when drilling for
installation of retrofit assembly hardware. inspect all wiring and components for damage.
WARNING: To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal
!
or other sharp objects.
CAUTION: Installation of this retrofit assembly requires a person fimiliar with the construction and
!
operation of LED luminaire electrical systems and the hazards involved./Confier l'installation de ce
necessaire de modernisation a une personne connaissant la construction et le fonctionemnet des
installations d'eclairege fluorescent et consciente des risques qu'elles comportent.
CAUTION: Do not alter, relocate, or remove wiring, lampholders, ballasts, or any other electrical
! components./Ne pas modifier, deplacer ni enlever de cable, de douille de lampe, de ballast
ou autre composant electrique.
CAUTION: Unless otherwise specified, do not make or alter any openings in the compartment of
!
wiring or electrical components during installation of this retrofit assembly. plug all unused
openings in the compartment of wiring or electrical components.
CAUTION: Only the holes indicated in the photographs and/or drawings may be made or altered
!
as a result of kit installation. Do not leave any other open holes in an enclosure of wiring or
electrical components.
MAINTENANCE: A regularly scheduled maintenance program should be established to retain optimum light
output and reduce heat retention. Dusting with a soft, clean, dry cloth is normally sufficient for the reflec-
tor. Do Not use alkaline or acid cleaners on reflector surfaces.
CAUTION: All wiring must be done by a qualified electrician.
KEEP THIS SHEET FOR FUTURE REFERENCE.
Contents of Kit: (1) TIR LED Deck
(1) Driver Assembly
Tools Required: Phillips Screwdriver
!
Make certain electrical supply is OFF before starting fixture.
02/05/21 EC 140218014
BNS1-LED
TIR Upgrade Kit Installation Instructions
™
Status 2 Part No. 93038091
Page 1