JVC RC-EX30B Manuel D'instructions page 23

Synchronized recording with CD playback
You can make the CD player to start playback when the tape deck enters the recording mode.
1 Load a cassette.
Use only a type-I normal tape.
2 Load a CD.
3 Press CD/RANDOM to enter CD mode.
You can press CD/RANDOM on the remote control
unit to enter CD mode.
4 To start recording from the desired track, select
the track by pressing 4 or ¢ in stop mode.
You can use the number buttons on the remote control
unit to select the track.
5 Press REC ¶.
PLAY 2 is also depressed, and synchronized
recording starts.
• The CD SYNC indicator appears in the display
window during synchronized recording.
Erasing
When recording on a pre-recorded tape, the previous
recording is erased and only the new recording is heard
next time the tape is played back.
3 1 5 2 4
PUSH
REMOTE
DISPLAY
SENSOR
When the tape reaches the end first, the CD player enters
the pause mode. Press PLAY/PAUSE 3/8 (or 3/8 on
the remote control unit) to continue playback, or press
STOP 7 (or 7 on the remote control unit) to stop
playback.
When the CD player stops first, the tape continues
running. In this case, press STOP/EJECT § to stop
the tape.
To erase a tape without making a new
recording
1 Press TAPE on the unit to enter the tape mode.
2 Press REC ¶.
4 3
4
STANDBY/ON CD/ TUNER/
RANDOM BAND TAPE
1 2 3
DISPLAY
4 5 6
HBS/
PRESET EQ
7 8 9
FM MODE
OVER
/BEAT CUT
0
PROGRAM/ +
UP INTRO
CLOCK SET
PRESET GROUP
REPEAT MUTING
–
DOWN
VOLUME
RM-SRCEX30J REMOTE CONTROL
20