Publicité
Step 16
Carefully stand your unit upright and position the unit in its fi nal location. We recommend using the SAFETY STRAP (60M)
å
for added stability.
NOTE: Do not turn the SAFETY DRYWALL ANCHOR (61M) into a wall stud. If you prefer to fasten the SAFETY
å
STRAP (60M) to a wall stud, go to your local hardware store for proper hardware.
INSTALLATION INSTRUCTIONS: (Also available at www.yl-anchors.com)
å
1. Insert the SAFETY DRYWALL ANCHOR (61M) through the WASHER (13M) and one end of the SAFETY STRAP (60M).
2. Using a Phillips screwdriver or a hand drill, press the screw slightly onto the drywall.
3. Apply pressure; turn the screw until a pilot hole is made and the nylon sheath slips through.
4. Turn the screw until it is fl ush against the wall and you feel a fi rm resistance.
5. Continue to turn until the screw starts spinning freely.
Insert the other end of the SAFETY STRAP (60M) through the gap between the TOP (C) and the BACK (F2), then use a
å
BLACK 9/16" LARGE HEAD SCREW (VV) through the SAFETY STRAP and into the pre-drilled hole in the underside of
the TOP.
NOTE: Before moving your unit to a diff erent location, unscrew the SAFETY DRYWALL ANCHOR (61M) from your wall.
å
The nylon sheath will remain behind your wall.
www.sauder.com/services
C
F2
13M
60M
BLACK 9/16" LARGE HEAD SCREW
(1 used in this step)
401323
61M
VV
Page 21
Publicité
