General Safety Instructions - Safco TASK MASTER 5110 Instructions De Montage

CHAIR ADJUSTMENT INSTRUCTIONS
To maximize the ergonomic benefits of this chair, it is essential to understand how the controls function and how they affect your posture.
ADJUST THE
HEIGHT RANGE:
The lever under the seat on the right side pneumatically adjusts
the height of the seat over a range of about 8". The proper height
should be determined by a combination of variables: the height
of the work surface, the task to be performed and your body size.
Typically, the chair should be high enough so your arms form a
90 angle at the elbow or slightly greater. This allows for better
o
circulation in the shoulders and neck area and also reduces the
amount of fatigue in the forearms and hands. The feet should lie
flat on the ground or footring. To help insure good posture,
maintain a 90 angle at the bend of the knees.
o
MAINTENANCE
The pneumatic lift in the Cylinder is permanently
lubricated at the factory and needs no further
lubrication. NEVER LUBRICATE THE
PNEUMATIC LIFT. Do not remove clip from
bottom of Cylinder. Contact Safco immediately
if clip is missing or damaged.
polyurethane seat and back with soap and water.
To repair small cuts in polyurethane, apply a few
drops of quick-drying glue into the cut and press
the sides together until the glue sets.
5110-37MP: 2 of 6; Rev. 3: 11/06
(7997.03)
ADJUST THE BACK
HEIGHT AND DEPTH:
Loosen the backrest height adjustment knob behind the seat.
Slide the backrest assembly up or down and adjust the height
of the back, which has a lumbar support curve to it. The knob
under the seat allows you to adjust the backrest forward and
back. Sit centered on the seat. The curve in the backrest should
fit into the small of your back. This will reduce the pressure on
the spinal discs, especially in the lumbar area.

GENERAL SAFETY INSTRUCTIONS

Do not stand on seat.
Chair must be on level surface to ensure proper
stability.
Only use chair when fully assembled.
Never use chair if it does not perform according to
Clean
this sheet or warranty may be void.
Immediately report any problems to Safco and
always give the manufacturer's date code
information from the label under the seat.
Safco Products Company, New Hope, MN 55428