Black & Decker BS600 Mode D'emploi page 5

Assembly
•
This appliance requires parts to be cleaned
before use. See "Maintenance and Cleaning"
for details.
Installing the jug
•
Place the jug onto the motor unit, positioning
the line moulded into the base of the handle
with the unlocked padlock symbol on the
motor base.
•
Turn the jug clockwise until the line is
positioned opposite the locked padlock
symbol. Ensure that the motor unit and the
jug are correctly assembled and securely
locked in position.
Installing the lid and filler cap
•
Line up the circle symbol on the lid with the
unlocked padlock symbol on the jug.
•
Lower the lid onto the jug, keeping the two
symbols aligned,
•
Turn the lid clockwise until the circle symbol
lines up with the locked padlock symbol.
Ensure that the lid and the jug are securely
locked in position.
•
To fit the filler cap, lower it onto the lid. Make
sure the lugs on the filler cap fit between the
two cut-out slots on the lid.
•
Push the filler cap down to lock into position.
Installing the drip tray
•
Slide the drip tray into the grooves on the
motor base.
Use
•
Remove the jug lid and place the ingredients
inside the jug. For best results, ingredients
should be cut into smaller pieces. Cut dry
ingredients into smaller pieces before
processing.
•
Replace the jug lid ensuring that the filler cap
is installed.
•
Fit the jug onto the motor base. Ensure the
jug and the lid are fitted correctly, otherwise
the smoothie maker will not work.
Warning! Make sure that the speed
control dial is set to the off position '0'
before plugging the smoothie maker
into the mains supply.
•
Plug the motor unit into a suitable mains
supply and switch on at the socket.
•
To start, set the speed control dial to setting
'1'. To increase the speed, turn the speed
control dial clockwise.
Note: '1' is the slowest speed setting and '3' is
the fastest.
•
Alternatively, blend the ingredients in short
bursts by turning and holding the speed
control switch to the PULSE setting. Release
it to stop.
Caution! Do not operate the unit
continuously for more than one minute
without a rest period of two minutes.
The filler cap can be carefully removed to feed
ingredients into the jug during processing if
required.
Warning! Do not place your fingers
inside the jug when adding ingredients.
•
Allow the ingredients to blend until smooth.
When processing is complete, set the speed
control dial to the off '0' position. Switch off
and unplug the blender from the mains
supply.
ENGLISH
5