Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
Stabilizer Bar
Stabilizer Bar Bracket
Receiver Shown In Proper Position
Equipment Required:
Fastener Kit: K65014
Wrenches: 7/8", 13mm
Drill Bits: None
1
Qty. (4)
Carriage Bolt, 1/2"-13 x 1-3/4"
2
Qty. (4)
Spacer, 1" x 2" x 1/4"
1.
Remove stabilizer bar fasteners and brackets allowing stabilizer bar to swing free.
2.
Raise stabilizer bar, receiver and stabilizer bar brackets into position and install all fasteners as shown. Receiver side brackets
go between frame rails and stabilizer bar brackets.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2005 Cequent Towing Products
Front Mounted Receiver
Installation Instructions
Ford F-250 HD 2WD & F-350
Diesel Engine Only
Frame Rail
Bumper
Frame Rail
Stabilizer Bar
Tighten all 1/2" GR5 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
Tighten all M8 CL9.8 fasteners with torque wrench to 20 Lb.-Ft (27 N-m).
CARGO CAPACITY – DO NOT EXCEED
500 LB. OR VEHICLE FRONT GROSS
AXLE WEIGHT RATING. (GAWR)
9000
Stabilizer Bar
Brackets
Existing Bolts
3
Qty. (4)
Conical Washer, 1/2"
4
Qty. (4)
Hex Nut, 1/2"
Sheet 1 of 3
N65014
Part Numbers:
65014
LB. MAX. WINCH LINE PULL
Existing Weldnuts
Typical Both Sides
Recovery Eye
11-07-05
Rev. A
Publicité
Manuels Connexes pour Cequent Towing Products 65014
Sommaire des Matières pour Cequent Towing Products 65014
- Page 1 Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. Sheet 1 of 3 N65014 11-07-05 Rev. A 2005 Cequent Towing Products...
- Page 2 Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage. Feuille 2 de 3 N65014 11-07-05 Rev. A 2005 Cequent Towing Products...
- Page 3 Este producto cumple con las especificaciones y requisitos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York. V.E.S.C. Regulación V-5 y SAE J684. Hoja 1 de 3 N65014 11-07-05 Rev. A 2005 Cequent Towing Products...