Samsung DVD-VR370 Mode D'emploi page 82

reference
TROUBLESHOOTING (DVD)
PROBLEM
icon appears on
the screen.
Play mode settings are different from the
settings confi gured with the Setting menu.
Cannot change the aspect ratio.
No audio output.
No video or audio output.
The disc tray is ejected after 2 to 5 seconds.
Angle operation does not work during
playback of a DVD disc.
The disc revolves, but no image or bad
quality images are output.
Desired audio language and subtitle language
are not played.
No progressive output.
The remote control doesn't work.
Other problems
No HDMI output.
(DVD-VR375 only)
Abnormal HDMI output screen.
(DVD-VR375 only)
HDMI output Jitter
(DVD-VR375 only)
82_ reference
EXPLANATION/SOLUTION
You cannot use the operation or function due to one of the following reasons:
(1) Your DVD disc does not support the feature (for example, angles)
(2) You've requested a title, chapter, or scan time that is out of the correct range.
The disc does not support all the selected functions.
In this case, some settings you confi gure on the Setting menu may not work properly.
Aspect ratio is fi xed for DVD disc.
Check whether you selected correct digital output options in the Audio Output Options menu.
Did you move your DVD Recorder & VCR suddenly from a cold place to a warm place?
In this case, do not connect the plug to the power outlet and wait for two hours.
Then insert the disc and try to play again.It will work properly when condensation has
evaporated.
Angle operation is available only when the disc contains images captured at different angles.
• Check whether there is damage or foreign materials on your disc.
• Some discs with bad manufacturing quality may not be played back.
• If the scene changes from dark to bright suddenly, the screen may jitter temporarily,
but it is not a defect.
Audio languages and subtitle languages are disc-specifi c.
Only the sound and subtitle languages contained on a DVD disc are available and
displayed on the disc menu.
• Check whether you selected correct Progressive options in the Audio Options.
• Point the remote control at the remote control sensor on your DVD Recorder & VCR.
Operate within distance. (15ft)
Remove obstacles between your DVD Recorder & VCR and remote control.
• Check whether the batteries are depleted.
• Read the table of contents and then fi nd and read the sections describing your
problem, and follow the directions given.
• Turn the unit off and on.
• If your problem still persists, contact your nearest Samsung service centre.
• Check the Video output is HDMI enabled.
• Check the connection between the TV and the HDMI jack of the DVD Recorder & VCR.
• See if your TV supports this 576p/720p/1080i/1080p DVD Recorder & VCR.
• If snow noise appears on the screen, it means that TV does not support HDCP (High-
bandwidth Digital Content Protection).
• Check your TV system setup correctly.
• Screen Jitter may occur when the frame rate is converted from 50Hz to 60Hz for
720p/1080i/1080p HDMI (High Defi nition Multimedia Interface) Output.
• Please refer to the user's manual of your TV.