Hose Routing And Connections - GeneralAire RMB35 Mode D'emploi

4.2 HOSE ROUTING AND CONNECTIONS

Connect the steam hose to the stainless elbow
fitting located at the bottom of the manifold and
secure with the hose clamp provided. Do not
force the steam hose onto the stainless fitting
- apply some water to the inside of the hose
and ease the hose onto the fitting. Connect the
condensate hose to the molded barbed fitting
on the right (See Figure 4.d). The condensate
hose needs to be trapped immediately under
the blower housing or directly above the steam
humidifier using a 6" loop in the condensate
hose. See the 5500 Steam Humidifier Installation
Manual.
The 3/8" x 3/8" barbed hose fitting enables the
condensate hose to connect to the fill cup.
Insert one end of the fitting into the condensate
hose (Figure 4.e), route the hose into the unit
through the hole in the enclosure, and then
insert the other end of the fitting into the hole
on the top of the fill cup (Figure 4.e.).
Fig. 4.d
NOTE:
1. Do not force the steam hose onto the
2. For information on hose connections in the
Condensate hose
Barbed tting
Hole in ll
cup lid
Page | 14
stainless fitting; this will cause the manifold
to break. Apply some water to the inside of
the hose and ease the hose onto the fitting.
steam humidifier, please see the humidifier
manual.