Installation - GeneralAire RMB35 Mode D'emploi

Insert the room steam kit housing into the wall
and bend the four securing tabs around the back
of the drywall. Level the room steam kit, then
secure to the wall using predrilled holes located
on the four one-inch flanges. Use #8 drywall
screws (four required) to penetrate the drywall
and pass through the slot in the securing tab
behind the drywall (See Figure 4.a and 4.b).
An alternate installation method is to frame
out the opening of the RMB to the dimensions
shown in Figure 3.b.
IMPORTANT!
The four one-inch flanges on the face of the
Room Steam Kit unit must be on the outside of
the drywall. Failure to locate the flanges on the
outside face of the drywall may result in water
leakage and household damage.
Fig. 4.a
VIS #8 PASSAGE À TRA-
VERS LA BRIDE AVANT ET
DANS LA FENTE DE LA
PATTE DE FIXATION
Kit vapeur DEVANT DE LA
Pièce

4. INSTALLATION

Fig. 4.b
Kit vapeur ARRIÈRE DE LA
Pièce
Page | 11
ENG
PATTES DE FIXATION
PLIÉES EN POSITION
POUR ÊTRE FIXÉES À LA
CLOISON SÈCHE
Part No. 5500-33 Rev B
Code: +03U400150 REV 4.2 20210708