Scell-it Element 007-T Manuel D'utilisation page 7

● HOLLOW WALL ANCHOR INSTALLATION:
1
Drill the wall to the
recommended diameter of the
HWA.
4
Insert the HWA into the hole:
the flange of the HWA should
be flush to the surface of the
wall (the small lugs slightly
recessed in the wall).
7
● HOW TO REMOVE THE BATTERY:
Battery is locked to the riveting tool with a spring.
To remove the battery, press the 2 unlock buttons
Do not force it.
2
Install the mandrel
1
corresponds to your HWA (M4 to
M8) - onto the tool.
See 'changing the mandrel' in the
user manual.
5
Check «reverse button»
correctly (pressed on the right side).
Pull the trigger to expand the HWA
and cause it to grip the wall securely.
In order to reduce wear and avoid stoppages, it
is highly recommended to regularly add some
grease on the end of the mandrel approximately
every 5 rivetnut settings (pot of grease
supplied).
Simply dip the mandrel into the pot and wipe
off the excess with a cloth if necessary.
3
- that Manually screw the HWA on
the mandrel
6
is set Release the trigger: the mandrel
12
will automatically unscrew; then
release the tool.
and slide the battery.
8
E-007 - User Manual
EN
FR
PL
CZ
IT
.
1
• 7