Scell-it Element 007-T Manuel D'utilisation page 6

1
EN
OPERATING INSTRUCTIONS
FR
PL
● ADJUSTING THE STROKE:
CZ
Use the stroke setting dial
• The stroke range is 4 to 40mm
IT
• Each notch is 1.2mm
In general, the stroke required for a perfect
installation depends on the length of the
hollow wall anchor.
But this can vary according to the different
designs of the HWA on the market.
ADVICE
Refer to the table for recommended stroke
settings.
Blank test a HWA and adjust the setting if
necessary.
● WARNING:
E-007-T does not have a clutch system. If the stroke is set too high, it could lead to
damage of the anchor or the plasterboard wall.
To avoid this, it is strongly recommended to carry out a «blank» test on a sample wall
before installing the anchor on the wall.
A good installation will be a deformation of the anchor legs between 90° to 110° (see
pictures below), which allows a good locking without damaging the wall (a slight
penetration of the legs into the wall is tolerated and even recommended for a tighter
hold):
6 •
E-007 - User Manual
on the back of the E-007:
6
90°
HWA
LENGTH
mm
23
33-37-40
46-47-50-53
63-66
75
80
110°
RECOMMENDED
STROKE SETTING
(data for information
only)
mm
8-12
16-18
24-26
24-26-28
38
40