AEG DD8694-M Mode D'emploi Et Installation page 8

HOOD bODy MOUNTINg
• Before attaching the hood body, tighten the
two screws Vr located on the hood body
mounting points.
• Hook the hood body onto the screws 12a.
• Fully tighten the support screws 12a.
• Adjust the screws Vr to level the hood
body.
cONNecTIONS
DUcTeD VeRSION AIR eXHAUST SySTeM
When installing the ducted version, connect the
hood to the chimney using either a flexible or
rigid pipe ø 150 or 120mm, the choice of which
is left to the installer.
To install a ø 150
• To install the dumper 10
• Fix the pipe in position using sufficient pipe
clamps (not supplied).
To install a ø 120
• To install a ø 120 mm air exhaust connection,
insert the reducer flange 9 on the dumper
10.
• Fix the pipe in position using sufficient pipe
clamps (not supplied)
.• Remove any activated charcoal filters.
���
�����
��
INSTALLATION
��
�����
�
��
8