Safety Instructions - YATO YT-82295 Instructions Originales

PRODUCT SPECIFICATION
The heat gun is an electrical device, with class II insulation, designed to produce hot airfl ow at high temperatures. Air at this tem-
perature facilitates, among others, removal of old oil paints and varnishes from e.g. furniture, wainscoting, fl oors, doors, windows,
etc. The device is not intended for commercial use. The correct, reliable and safe operation of the device depends on its proper
use, therefore:
Read the entire manual before the fi rst use of the device, and keep it for future reference.
The device supplier shall not be liable for any damage resulting from failure to comply the safety instructions and recommenda-
tions specifi ed in this manual.
DEVICE EQUIPMENT
The heat gun is equipped with additional nozzles.
TECHNICAL PARAMETERS
Parameter
Catalogue No.
Rated voltage
Rated frequency
Rated power
Airfl ow temperature
Airfl ow speed
Insulation class
Net weight
Protection rating

SAFETY INSTRUCTIONS

Irresponsible use of equipment can cause fi re, therefore exercise caution when using the
equipment in areas where combustible materials are present; do not direct a stream of hot
air at the same spot for an extended period of time; do not use the equipment in an explosive
atmosphere; be aware that heat may be transferred to combustible materials out of sight;
place the equipment on its stand after use and leave it to cool down before storage; do not
leave the equipment unattended when switched on. Before starting work, make sure that the
housing and the power cord and plug are not damaged. In case of damage, do not proceed
with work. This device must not be used by children. Children should not play with the device.
Children left unattended should not be allowed to perform the cleaning and maintenance of
the device. This device may be used by persons with reduced physical, mental abilities and
persons with no experience or knowledge of the device, if supervised or instructed on its
safe use so that the risks associated with it are understood. The device is not designed to
operate in high humidity conditions. The temperature at the place of the device's use must
be within the range of +10
condensation. Do not expose the device to precipitation. Before connecting the device to the
power supply, make sure that the voltage, frequency and performance of the power supply
correspond to the values shown on the device's rating plate. The plug must fi t into the socket.
It is forbidden to modify the plug or socket in any manner to make them fi t. The device must
be connected directly to a single power supply socket. It is forbidden to use extension cords,
adapters or double sockets. The mains circuit must be equipped with a 16 A protection. Avoid
O R I G I N A L
GB
Unit
[V~]
[Hz]
[W]
[ºC]
[l/min.]
[kg]
C ÷ +38 C, and the relative humidity must be below 70% without
O O
I N S T R U C T I O N S
Value
YT-82295
220 – 240
50
2000
50 – 600
250 - 500
II
0.84
IPX0
9