Danfoss VSH Instructions page 3

Oil injection
control valve
Oil injection control assembly
3 2 1
Put the clip-on coil (1) with the gasket (2) over
the valve body (3) on the compressor
Oil injection control dismantling
The compressor must only be used for its
designed purpose(s) and within its scope of
application (refer to «operating limits»).
Consult Application guidelines and datasheet
available from http://cc.danfoss.com
3
InstructIons
VsH compressors
A
B
C
A: Model number
B: Serial number
c: Refrigerant
D: Supply voltage & Locked rotor current
70
65
60
55
50
45
40
35
30
25
20
15
-30 -25
4
Attach the connector (4) to the coil using the
delivered accessories (5) and (6).
Remove the clip-on coil by using a screw
driver.
Under all circumstances,
the EN378 (or other
applicable local
regulation) requirements
must be fulfilled.
FRCC.EI.005.A3.02 © Danfoss Commercial Compressors 09/10
e: Housing service pressure
F: Factory charged lubricant
G: C ompressor frequency & Max Must trip cur-
r410A
SH=6K
30 - 90 Hz
-20 -15 -10 -5
T (°C)
0
5 6
Wire the connector as indicated.
The compressor is delivered under
nitrogen gas pressure (between 0.3
and 0.7 bar) and hence cannot be
safety
connected as is; refer to the «assem-
bly» section for further details.
D
E
F
G
rent
50 - 90 Hz
0 5 10 15
220V
2 A max
The compressor must be
handled with caution in the
vertical position (maximum
offset from the vertical : 15°)
20