Fixed Or Rocking Position Of The; Use With The Stroller; Cleaning And Storage; Warnings - Chicco Auto-Fix Fast Mode D'emploi

1. Remove the shoulder pads by unthrea-
ding them through the slots in the fabric
cover.
2. Press the red button to open the harness
buckle.
3. Slide the harness straps out from behind
the backrest and thread them though the
slot which is most suitable for the child's
height (Diag. 27A and 27B).
WARNING! Make sure that the harness
straps are always threaded between the
slot element ( R) and the shell.
WARNING! The booster cushion guaran-
tees correct containment and the ideal
position for the neck and back of babies
from when they are born until they weigh
about 6 Kg.
3.3 FIXED OR ROCKING POSITION
OF THE CHILD SEAT (ROCKER
CHAIR MODE)
When the child car seat is not used inside
the vehicle, it can be used as a rocking or
static chair.
To allow it to rock, close the stabiliser block
(Diag. 14) and move the carry handle to
position B (Diag. 5).
To use it in fixed mode, fold out the stabiliser
block and move the handle bar to position
D (Diag. 5).
Only place the child seat on stable hori-
zontal surfaces.
WARNING! Before carrying the child car
seat, always bring the carry handle into a
vertical position (B).
WARNING! Never leave your child
unattended.
WARNING! Always use the re-
straint harness.
WARNING! Using the child car seat
on raised surfaces such as tables,
chairs etc can be very dangerous.
WARNING! This child car seat is
not designed for long periods of
sleep.
WARNING! Do not use the seat
when the child is able to sit up on
his own.
This child car seat is not a replacement for a
bed or cot. If the child needs to sleep, they
should be moved to a bed or a cot.
Do not use the child seat if some of its parts
are broken or missing.

3.4 USE WITH THE STROLLER

WARNING! Please read the Stroller instruc-
tion manual when using the child car seat
on the stroller. The CHICCO strollers, which
use the CLIK CLAK system, have armrests
with special devices that allow you to fasten
the child seat to the stroller frame without
any need for additional fixtures.
To install the child seat on the stroller, pro-
ceed as follows:
1. Bring the carry handle into a vertical po-
sition (Diag. 28).
2. Connect the two Clik Clak fastener pins
on the child seat (N) to the arm rests on
the Stroller, making sure that both sides
are fastened correctly. You will hear them
click into place (Fig. 29).
WARNING!
Before use, ensure that all the child seat-
fastening devices are correctly fitted in
place.
To remove the child seat from the strol-
ler:
1. Bring the carry handle into a vertical
position (B).
2. Pull the rear release handle.
3. Remove and place the child seat on a flat,
stable surface.
WARNING: The child seat can be fastened
and unfastened with the baby inside; these
procedures could prove to be more difficult
due to the weight of the baby. Be very care-
ful when performing the above-indicated
procedures.

3.5 CLEANING AND STORAGE

HOW TO CLEAN THE FABRIC
COVER
The child seat's fabric cover can be remo-
ved and cleaned by hand or in a washing
19