Quax COCOON 54F01-0400 Serie Manuel page 38

COCOON 54F01-0400x
Step 4.8 : Use the parts from step 4.3 and step 4.4, the construction from step 4.7, twelve wood screws D, both backs
18, seven panel clamps J, thirty-seven wood screws I and four legs M.
Position the bottom with the legs (4) in front of the holes in the sides and the intermediate side. Push the wood screws
(D) into the holes at the underside of the bottom and tighten them in the sides. Place the top (5) in front of the holes in
the sides and the intermediate side. Push the wood screws (D) into the holes at the upperside of the top and tighten them
in the sides. Place the backs (18) in the cut-outs of the top, bottom and sides. Check if both angular distances are the
same. Connect both back at the height of the intermediate side by means of the panel clamps (J). Push a wood screw
(I) into the clamps and tighten in the intermediate side. Fix the backs to the sides, bottom and the top by means of thirty
wood screws (I). Screw the legs (M) onto their mounting plates.
Step 4.9 : Use the drawer front 13, the drawer sides 14 and 15, two connectors F, two wooden dowels E and two minifi x
G
Tighten the connectors (F) in the drillings on the inside of the drawer front (13). Push a wooden dowel (E) into the holes
on the front of the drawer sides (14 and 15). Push a minifi x (G) into the drilling on the inside of the sides.
Quax nv Karel Picquélaan 84 B-9800 Deinze Belgium T T 0032 9 380 80 95 www.quax.eu - E E info@quax.eu
38