Publicité
6
RETAIL_2
A
B
7
RETAIL_3
B
C
8
SPA
A
9
CHURCH
C
C
KEYPAD OPERATION
- Press On/Off to switch all the groups off.
- Press the UP and DOWN arrows to adjust all the lights.
- Press the scene keys to recall the selected scene.
- Press the group key:
Press it quickly: group on/off
Hold it down (monochromatic): quick up/down dimming (release and press again to change the adjustment direction).
Hold it down (RGB/W): quick colour wheel; recalling of loop possible when colour wheel goes to white and flashes three times.
Scene fading: 3s.
Loop speed: medium (default)
- Scene change: change the group switch-on using the individual group keys and create a new scenario. Press the scene key where you wish to save the new scenario. A beep is heard and flashing is seen as a
confirmation of saving.
NOTE: Scene 1 cannot be overwritten in the presence of a light sensor
- Daylight scene: when recalled, the key flashes three times.
- To change the setpoint adjust the intensity of the lights of either the individual monochromatic group or an environment
- The new setpoint is saved approximately 1 minute after no interaction with the panel has occurred. The key flashes three times as a confirmation.
BEST ENERGY SAVING (B.E.S.) between light sensor and presence sensor.
If both a light sensor and a presence sensor are present, make sure that:
- if the group controlled by the light sensor is at minimum light intensity,
- at the same time the light sensor is still sending DIM DOWN commands,
as a consequence the monochromatic light controlled by the sensor switches off and does not switch on again - not even with presence - until:
- there is a change in ambient-light conditions so that the light sensor starts sending a DIM UP command.
- at the same time the presence sensor reports that the environment is still busy.
COMFORT SWITCH OFF (C.S.O.) from presence sensor.
The presence sensor switches off in a similar way as a "courtesy lamp", i.e. the lights takes 30s to dim down.
This makes it possible for any user still in the environment (and not visible to the sensor for a time equal to timeout) to avoid a sudden switch-off. A little motion will bring the lights back to their starting level.
In any case a gradual switch-off is always more pleasant than a sudden one.
NOTE: If the lights are already at their minimum level, the switch-off will be immediate.
A=l.monochrom_1
A
B=l.monochrom_2
C=l.monochrom_3
D=l.monochrom_3
B
D
C
A= counter
B
B= shop front
C=monochrom_1
D=monochrom_2
C
D
A
A=RGB_1
B=RGB_2
C=RGB_3
D=monochrom.
B
D
C
A=altar
B=nave
C=aisle
D=dome
B
A
D
Type: lux
S1:A=B=C=D=50%/
Daylight (Morning)
Adjustment type:
S2:A=B=C=D=100%
The light sensor can be
(Afternoon)
connected anywhere
S3:A=100%
B=50%
C=D=OFF
(Night)
Type: lux
S1:A=Fixed blue colour
B=loop
Adjustment type:
C=D=50%
The light sensor can be
/ Daylight
connected anywhere
(Morning)
S2:A=Fixed blue colour
B=loop
C=D=100%
(Afternoon)
S3:A=B=loop
C=D=OFF
(Night)
S1:
A= Fixed red colour
B= Fixed red colour
C=loop
D=70%
S2:
A= Fixed red colour
B=loop
C=loop
D=70%
S3:A=B=C=loop;
D=70%
S1:A=B=C=D=100%/
S2:A=100%
B=C=D=80% ( mass)
S3:A=70%
B=C=D=30% (service)
5
2s monochrom
morning afternoon
Loop :
MEDIUM
2s monochrom
Loop :
MEDIUM
morning afternoon
2s monochrom
Loop : SLOW
morning
2s monochrom
LMS QUICK
night on/off
group
group
group
group
A
B
C
D
LMS QUICK
night on/off
group
group
group
group
A
B
C
D
LMS QUICK
afternoon
night
on/off
group
group
group
group
A
B
C
D
LMS QUICK
cleaning
general service
on/off
group
group
group
group
A
B
C
D
Publicité
