Horizon Global 118741 Instructions D'installation page 3

Always wear SAFETY GLASSES
when installing wiring harness
1. Open the Hatch of the vehicle and temporarily remove the rear threshold, cargo net and cargo cover to allow access of the rear interior trim panel on the driver's side.
NOTE: It may be helpful to fold rear seat forward.
2. Carefully remove the lower cargo hook by pushing in on white plastic clip. Using a Trim Panel Remover Tool, carefully pull back the upper and lower trim panels on the driver's side.
3. Gently pull back the upper trim panel to reveal the vehicles white 6-pin connector. Connect the T-One® T-Connector harness in vehicles white 6-pin housing and lock in place.
4. On the driver's side, locate existing ground stud. Loosen bolt, place screw eyelet on stud and re-tighten bolt.
Ensure all existing grounds connections are still attached. Torque Existing ground screw to manufacture Torque Specifications.
5. Apply the Supplied Double-sided tape to the flat side of the black box. Locate a flat surface in and out of the way location. Mount the T-One® T-Connector's black box-module. to prevent damage or rattling.
NOTE: Clean flat mount surface area using a 50-50 mixture of rubbing alcohol and water to mount lighting module black box.
)
2017-2022 Models, (All Styles
6-A. Locate the interior fuse compartment under steering column. Remove the cover for the fuse compartment. Remove the Fuse compartment lid and locate fuse location 37, if not installed insert the 15-amp the included hardware kit.
*NOT available on all models.
2023-Current Models (All Styles)
6-B. Locate the interior fuse compartment under steering column. Remove the cover for the fuse compartment. Remove the Fuse compartment lid and locate fuse location 17, if not installed insert the 15-amp the included hardware kit.
*NOT available on all models.
Overloading circuits can cause fires. DO NOT exceed stated product ratings. Read vehicle's owner's manual & instruction sheet for additional information.
Replacing fuse that exceed product fuse am rating and Vehicle fuse amp rating could result in damage of vehicle and or other attached accessories.
Read and follow all warnings and cautions printed on the tow vehicle's battery. All connections must be complete for the T-One® T-Connector to function properly. Test and verify installation with a test light or trailer once installed. For initial
test, reset vehicle electrical system by temporarily removing the key from the ignition.
7. Secure the remainder of the T-One® T-Connector harness with the cable ties provided, to prevent damage or rattling and being careful to avoid any areas that would pinch, cut or melt the wire.
8. Reinstall the plastic trim panels, threshold, storage covers, floor covering and other items that may have been removed during installation, being careful not damage any mounting clips or parts of the installed T-One® T-Connector harness.
NOTE: When 4-Flat harness is not in use. Store 4-Flat harness in an out of the way area in the rear cargo compartment.
©2023 Horizon Global™ Corp
Installation Instructions
PART NUMBER: 118741
Sheet 3 of 12 118741-N 1/25/2023 Rev. A