Installation; How To Set The Unit; Main Function - Nicols SPLENDOR LED Manuel D'utilisation

Input Voltage A C 230V 50Hz
： ： ： ：
Power consumption 3 4W
：
LED: 2 x 10W Tri-color LEDs 30000hrs rated
Dimension ： ： ： ： 296 x 271 x 140 mm
Weight 3.8kgs
： ： ： ：

3. Installation

The unit should be mounted via its screw holes on
the bracket. Always ensure that the unit is firmly fixed
to avoid vibration and slipping while operating.
Always ensure that the structure to which you are
attaching the unit is secure and is able to support a
weight of 10 times of the unit's weight. Also always
use a safety cable that can hold 12 times of the
weight of the unit when installing the fixture.
The equipment must be fixed by professionals. And it must be fixed at a place where is out
of the touch of people and has no one pass by or under it.

4. How to set the unit

4.1 Main Function

To select any functions, press MENU button until the required one is shown on the display.
Select the function by ENTER button and the display will blink. Use DOWN and UP button
to change the mode. Once the required mode has been selected, press ENTER button to
setup or it will automatically return to the main functions without any change after idling 10
seconds. Back to the functions without any change press MENU button.
The main functions are shown below:
16
DMX 512 Address Setting
Press the MENU button up to when the
button and the display will blink. Use DOWN and UP button to change the DMX 512
address. Once the address has been selected, press ENTER button to setup or
automatically exit menu mode without any change after 10 seconds. Back to the previous
functions without any change press MENU button.
Channel Mode
Press the MENU button up to when the
button, Use DOWN and UP button to select the
) mode. Once select, press the ENTER button to setup or automatically exit menu mode
without any change after 10 seconds. To go back to the functions without any change press
the MENU button
Slave Mode
Press the MENU button up to when the
button, Use DOWN and UP button to select the
(Slave 2) mode. Once select, press the ENTER button to setup or automatically
is shown on the display. Pressing ENTER
is shown on the display. Pressing ENTER
(1 channel) or (3 channels
is shown on the display. Pressing ENTER
(master) or (slave 1) or
17