Safety Instructions; Technical Specifications - Nicols SPLENDOR LED Manuel D'utilisation

TABLE OF CONTENTS
1. Safety Instructions
2. Technical Specifications
3. Installation
4. How to set the unit
5. How to control the unit
6. DMX 512 Configuration
7. DMX 512 Connections
8. Troubleshooting
9. Fixture Cleaning
14

1. Safety Instructions

Please read the instructions carefully which includes important
information about the installation, operation and maintenance.
WARNING
Please keep this User Manual for future consultation. If you sell the fixture to another
user, be sure that they also receive this instruction booklet.
Unpack and check carefully there is no transportation damage before using the fixture.
Before operating, ensure that the voltage and frequency of power supply match the
power requirements of the fixture.
It's important to ground the yellow/green conductor to earth in order to avoid electric
shock.
Disconnect main power before servicing and maintenance.
Maximum ambient temperature is Ta : 40℃. Don't operate it where the temperature is
higher than this.
In the event of serious operating problem, stop using the fixture immediately. Never try
to repair the fixture by yourself. Repairs carried out by unskilled people can lead to
damage or malfunction. Please contact the nearest authorized technical assistance
center. Always use the same type spare parts.
Do not connect the device to any dimmer pack.
Do not touch any wire during operation and there might be a hazard of electric shock.
To prevent or reduce the risk of electrical shock or fire, do not expose the fixture to rain
or moisture.
The housing must be replaced if they are visibly damaged.
Do not look directly at the LED light beam while the fixture is on.
There are no user serviceable parts inside the fixture. Do not open the housing or
attempt any repairs by yourself. In the unlikely event your fixture may require service,
please contact your nearest dealer.
Due to the magnifying type lens, please keep the lens out of contact with direct
sunlight. Direct sunlight can cause heat to build up inside of the unit, which will
seriously damage unit.
You should never look at the beam light directly in order not to risk any visual
disorders.

2. Technical Specifications

Fitted with 2 x 10W tri-color LEDs, the DMX Fury LED fills the entire room with
powerful and laser-like muticolor beams, delivering fabulous effects.
Great built-in lighting shows under Master/Slave and Sound Active
Full range dimmer and variable strobe effects.
Optional CA-8 easy controller for enjoying instant lighting shows at you fingertips
LED display for easy navigation
Idear for discotheques, clubs, bars, parties, Mobile DJs, etc.
15