Adjusting The Height Of The Headrest - CASUALPLAY Kangur fix Mode D'emploi

Instructions for use

ADJUSTING THE HEIGHT OF THE HEADREST

• The harness straps should both be at the same height. Adjust the
height of the harness by altering the height of the headrest.
• Loosen the harness as far as it will go. To do this, press the harness
adjustment button while pulling the straps with your other hand (fig.1).
• Unlock the headrest adjuster, found on the back of the backrest (fig.2).
• Place the headrest at the required height (fig3-4), and lock the adjuster (fig5).
ADJUSTING THE RECLINING POSITION
• The seat has three reclining positions.
• Pull the front lever at the bottom and keep it activated.
• Push the backrest to the required position and release the lever (fig.6).
NOTE: Make sure that the backrest is not midway between two positions.
Fitting and adjusting the support leg
• Press the button and insert the end of the support leg into the front slot
(fig.7). It will click when correctly in place (fig.8).
WARNING: pull the support leg to make sure that it is installed correctly.
• To adjust the support leg press the adjustment button on it, and unfold
it until it touches the floor of the vehicle (fig.9).
• A green indicator on the support leg will appear when it is correctly fitted.
• Check that the support leg is locked and that it stays in place, make
sure that it does not move upwards or downwards.
NOTE: Make sure that the support leg is correctly locked into one of the
adjustment positions.
INSTALLING THE KANGUR FIX IN THE VEHICLE (GROUP 1, 9-18 KG)
inSTALLing ThE SAfETy SEAT wiTh iSOfix COnnECTORS AnD SUPPORT LEg
• Find the ISOFIX anchors on the vehicle seat. These are located
between the backrest and the seat (fig.10).
20