Using The Appliance - Qilive Q.5856 Manuel D'utilisation

2. DESCRIPTION
1. Handle
2. Lid

3. USING THE APPLIANCE

Open the lid and fill the kettle with the desired amount of water. Never fill above the maximum
mark.
Close the lid and make sure the kettle is off before placing it on the base.
Make sure the lid is properly closed, otherwise the kettle will not stop automatically once the water
is boiled.
An automatic shut-off system has been installed to protect the appliance from overheating.
It will be activated if the kettle is switched on when it does not contain enough water. If the
automatic shut-off system is triggered, switch the kettle off, unplug it and leave to cool for 5-10
minutes. Then fill up again with water and switch back on: the kettle should boil and turn off again
normally.
Place the electric base on a dry, flat surface. Place the kettle on top of the base. The electrical
connection will be made automatically as soon as the kettle is placed on the electric base.
Plug the power cable into a grounded socket, and turn the kettle on by pressing the ON/OFF
switch. The indicator light will switch on.
Once the water has boiled, the kettle and indicator light will switch off automatically. After the
kettle has been left to cool for 15-20 seconds, the water can be boiled again by pressing the ON/
OFF switch. During the cooling period, do not press the ON/OFF switch as this may damage the
operating mechanism.
Do not remove the kettle from the base until it has been switched off.
You can pour water without opening the lid.
2
7
6
3. Button to open lid
4. On/off switch
5. Electric base
3
1
4
5
6. Spout
7. Filter
5
EN