Storage - Gardena C 2030 duo plus Mode D'emploi

1874-20.960.01_02.07.2011_GARDENA.qxp 18.07.2011 12:44 Seite 25
3.
Reset :
Important information :

6. Storage

Storage /
Overwintering :
3. Whilst the watering time in minutes is flashing, the watering
duration can be modified with the
0 : 00 0 : 59
and ) (example:
OK-key.
4. Press Man.-key to close the valve early.
The valve is closed.
The amended manual opening period is stored, i.e. each time
the valve is opened manually in future the modified opening
period is preset. If the manual opening period is amended to
0 : 00
, the valve is closed and also remains closed after the
Man.-key is pressed (child lock).
If the valve has been manually opened and a programmed start
of watering overlaps with the manual opening duration then the
watering programme will not be carried out.
Example :
The valve is opened at 9.00 a.m. manually, the opening period
is 10 minutes. A program with a start time between 9.00 and
9.10 a.m. will not be undertaken in this case.
The factory settings are restored.
v Press Man.-key and Menu-key simultaneously for 3 seconds.
All the LCD symbols are displayed for 2 seconds and the
display moves to the normal display.
• All the program data are set to zero.
• The manual watering period is set to
• The time and day of the week are retained.
If no entry is made during programming for a period of more than
60 seconds, the normal display reappears. In this case all changes
made up till now will be applied.
If a sensor inserted in the Water Computer registers wet (wet),
the corresponding programme will not be carried out.
1. To preserve the battery, it should be removed (see
4. Initial Operation).
The programmes remain stored. If the battery is inserted
again in spring, only the time of day and the weekday must
be newly entered.
2. Store controller and valve unit in a dry place where they are
protected from frost.
- button (between
10
minutes) and confirm with the
0 : 30
again.
25