Initial Operation - Gardena C 2030 duo plus Mode D'emploi

1874-20.960.01_02.07.2011_GARDENA.qxp 18.07.2011 12:44 Seite 19
2 Bars
Battery half full
Valve opens.
The Water Computer
is guaranteed to
work for a minimum
of 4 more weeks.

4. Initial Operation

Insert battery:
Connect soil moisture
or rain sensor (optional) :
H
I
J
1 Bar
Battery low
Valve opens.
The Water Computer
will continue to work
for no more than
4 weeks.
It is advisable to
change the battery.
v Replace battery (see 4. Initial Operation "Inserting battery" ).
The Water Computer must only be operated with a 9 V alkali-
manganese (alkaline) battery type IEC 6LR61.
1. Remove controller
housing of the Water Computer.
2. Insert battery in the battery
compartment
correct polarity
shows all the LCD-symbols for
2 seconds and then moves to
the time / day of week level.
F
3. Install controller
housing again.
Set display to 24-hours or 12-hours (am / pm) :
The factory setting is the 24-hour display.
v Press the Man. button continuously while inserting the
battery.
The Water Computer is fitted with a sleeve nut
(G 1 " ) (33.3 mm) thread. The adaptor supplied
Water Computer to be connected to taps with a (G ³⁄₄ " ) thread
(26.5 mm).
1. For tap with a G ³⁄₄ " (26.5 mm) thread :
Screw adaptor
2. Screw sleeve nut
thread by hand (do not use pliers).
3. Screw Tap Connectors
outlets.
0 Bar flashing
Battery almost flat
Valve still opens.
The Water Computer
stops working soon.
The battery must be
changed soon.
F
from the
G
. Observe
z
. The display
P
z
P
F
on the
H
on to the tap manually (do not use pliers).
I
of the Water Computer on to the adaptor
J
onto the two Water Computer
Frame is flashing
Battery flat
Valve does not open.
The Water Computer
stops working.
The battery must be
changed.
G
I
for taps with
H
allows the
19