Volvo Penta 876796 Instructions De Montage page 4

Hub 1542236
These assembly kits contain:
Designation
Shaft with impeller
Ball bearing 30/6206
Seal ring
Press the hub so that the shaft protrudes 12 mm.
Please refer to the illustration. This applies to the
following engines:
31 engines with serial numbers up to 2203116853
41 engines with serial numbers up to 2204141572
Hub 860455
These assembly kits contain:
Designation
Gasket
Single row ball bearing
Circlip
Press the hub so that it is flush with the shaft.
Please refer to the broken line on the illustration.
Applies to the following engines:
31 engines with serial numbers above 2203116854
32 engines, all
41 engines with serial numbers above 2204141573
42 engines, all
43 engines, all
44 engines, all
D300 engines, all
Qty Pos in figure.
1 1
1 2
1 3
Qty Pos in figure.
1 4
1 5
1 6
Installation of seal impeller
Only 31/32/41/42/43/44
The impeller should be pressed on until it is 0.8±0.15
mm below the seal plane. Measure with a feeler gau-
ge and tubular rule.
Only 300
The impeller should be pressed on until it is
0.25±0.15 mm below the seal plane.