ATH-Heinl 7 Mode D'emploi page 77

Les langues disponibles

4. Hydraulic oil

a. Fill in the hydraulic oil until the marking on the dipstick

b. For venting of the hydraulic circuit leave the tank cap open for the first 10 lifting movements.

5. Electrical connection

Hereby must be observed the general and local regulation. Therefore, this step can only be done

trained/skilled persons/experts.

only by

Pay attention to the necessary supply (see technical data).

6. Install on the platform the foldable front extension with pneumatic wheel clamping.

7. Control before the first lifting

a. all screws, nuts and so on for tightness

b. all connections and cylinders for leaks and retighten them if necessary

c. the oil level

d. all electrical connections (see electric diagram) as well as the ground cable

e. that the hydraulic system will be vented completely by lowering the lift completely and

pushing for appr. 15 seconds the button lowering further.

f. the function of the limit switch (OPT)

g. that the sliding guides of the base frame and the platform are lubricated (see lubrication

plan)

8. Lifting under load

a. Lift a load to appr. 500 mm height

b. Check that all the mounting points are in contact with the vehicle. If all points are in contact

with the car, the stage is straight.

9. Fill in after installing the enclosed checking book.

This information will be required in case of a possible claim.

These instructions are not to be viewed as assembly instructions; hints and tips are

provided only for trained expert installers. Suitable clothing and personal protection must

be worn for the following work.

Incorrect installation and settings lead to exclusion of liability and warranty.

Partly pre-assembled machines must be checked, introduced and approved by a competent person before

commissioning.

Machine assembly must be carried out by a qualified and competent person.

Manufacturer ATH-Heinl GmbH & CO.KG

- 24 -

7f 7q 7qf