Error Code List - JVC MC-8100LU Manuel D'instructions

10-2. Error code list

Device
Error
Device
part
code
01
02
03
C U 04
05
08
09
10
C L 11
12
20
21
22
23
24
25
C C 26
27
28
29
30
31 *2
41
C
D 42
43
80
F
81
E 50
M L 51
T 52
60
T
61
C 62
(D#)
E 63
*1
D 64
S 65
*1: # represents the drive number.
*2: Check the magazine loading condition. (
10-3. How to cancel Errors "20", "21" and "64"
These errors indicate that the disc is not being moved normally. As the errors cannot be canceled by turning the power off and
then on again, please contact your dealer or local JVC-authorized service agent in order to restore normal operation.
How to restart
CAUTION
First remove the jammed tray or media, otherwise the media may be damaged during subsequent operations.
1.
Turn off the Power.
2.
Open the door, remove the side and center panels.
3.
Remove the disc or tray from inside the carrier.
UP/DOWN rotary sensor does not change
Left slit sensor does not change
Right slit sensor does not change
UP/DOWN motor does not function
UP/DOWN motor doesn't work correctly or rotary sensor defective
UP/DOWN operation exceeds the predetermined duration
Upper or lower limit sensor turn on during UP/DOWN operation
Tray lock release not possible
Tray lock impossible, or lane change not possible
Tray lock does not exist at the initial position during carrier movement
a
Catcher (right left) movement operation exceeds the predetermined duration
a
Catcher (left right) movement operation exceeds the predetermined duration
a
Catcher (right left) convergence operation exceeds the predetermined duration
a
Catcher (left right) convergence operation exceeds the predetermined duration
a
Catcher (right left) tray rotary sensor does not change
a
Catcher (left right) tray rotary sensor does not change
Right catcher sensor does not turn on
Left catcher sensor does not turn on
a
Catcher motor (right left) does not function
a
Catcher motor (left right) does not function
Tray does not exist
Magazine insertion incomplete, or sensor defective
Destination-unknown tray exists on the carrier
No disc in the tray
Flip tray does not exist
During the flip raise operation, the expected time required is over
During the flip descent operation, the expected time required is over
Mail Slot ejecting is not possible
Mail Slot loading is not possible
Destination-unknown tray exists in the Mail Slot
Destination-unknown tray exists in the Drive and the control cable of the Drive is disconnected.
Tray removal is not possible at the drive position
Disc clamp of the drive does not function
Drive ejection is not possible
Failure to remove the disc from the drive
Spindle motor fails to stop (Ejection inhibited status)
a
See "9-1. Ejecting/loading the magazines" on page E25.)
Description
4.
Replace the panels and close the door. Then turn on
the power while holding down the "0" key on the control
panel.
Error Codes
E29