Magazines; Ejecting/Loading The Magazines - JVC MC-8100LU Manuel D'instructions

Bibliothque cd/dvd
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

9. MAGAZINES

CAUTION
• Do not use a magazine which has been damaged (e.g. dropped), as normal operation cannot be accomplished with
such a magazine. In addition, the use of such a magazine may damage the internal mechanism.
• The magazines and trays used with the MC-1000/2000 series CD-ROM Library (MC-M15U) are not compatible with those
used with the MC-8000 series CD/DVD Library. Do not interchange the magazines and trays between these models, as this
will damage the equipment.
• If it is required to take out or attach a magazine during operation, be sure to perform optimum software processing at the host
in advance.

9-1. Ejecting/loading the magazines

Ejection
1.
Open the door. ( a See "5. Door Opening/Closing" on page E17.)
* Do not turn off the power switch.
2.
Pull the release lever toward the front.
• The magazine unlocks and comes out slightly toward the
front. Be careful not to get your finger caught between
the release lever and grip.
3.
Pull the magazine straight toward the front.
• Use care not to hit or drop the magazine.
• Be careful not to touch the tray lock by mistake.
A tray may spring out.
Loading
1.
Check the orientation of the magazine.
• The [ c TOP] marking is provided on the grip to indicate the
upper direction of the magazine.
2.
Align the magazine rails with the guide on the main unit
(changer) and insert it straight forward.
• Insert the magazine slowly. Inserting it with a strong force
may damage the equipment.
• Ensure that the magazine guides are fitted in the guides
located at the left side of the library (both at the top and
bottom of the sides).
3.
Push in the magazine completely until it stops.
• Then, pull the magazines slightly toward the front to en-
sure that it is locked.
4.
Close the door (See "5. Door Opening/Closing" on page E17.)
* If a magazine was removed and installed and the door closed
after the power has been turned on, this function will automati-
cally check the disc status inside the magazine.(provided that the
automatic disc checking function has been turned ON APage E27).
Display in case of incomplete insertion
The front panel display will indicate an error if the door is closed while the magazine insertion is incomplete. Check the
incorrectly inserted magazines from the displayed message and re-insert them completely until they are locked.
E R R O R
O C C U R R E D !
D I S C = – – –
C O D E = C C – 3 1
Release lever
2
3
Grip
T O
P
Tray lock
The magazine guides are fitted
in the guides located at the left
side of the library
E R
R
O R
M A G A Z I N E
N o . :
2
Display when the insertion of magazine
No. 2 is unsatisfactory
TOP
E25

Publicité

Table des Matières
loading

Table des Matières