JVC MC-8100LU Manuel D'instructions page 10

3. SETUP
The standard setup procedure is shown below. Set up the equipment accordingly.
Unpack and check that all the attachments are included.
Remove the transport protective materials (2 places.)
A large number of discs can be loaded quickly(bulk load).
1
*
Please have your dealer or nearest JVC service center perform this task.
2
*
Start
Open the transport lock
Mount the optional carrier *
Install the drive units
Initial setup of SCSI-ID No., etc.
Connect the power cord and cables
Execute the automatic drive detection mode.
Turn the power switch on.
Load discs in the magazines *
Completion
Proceed to the host computer setup
P.E10
P.E11
2
.
P.E21
P.E12
P.E13
P.E23
1
P.E18, E26
E9