ATH-Heinl Comfort Lift 2.35 Mode D'emploi page 78

1. Preparation
b. Lower the lift completely until the arm restraints device is deactivated.
c. Place the lifting arms parallel to the drive direction.
d. Drive the vehicle between the columns, paying attention by the load distribution.
e. Adjust swing arms so that the vehicle is positioned with the center of gravity midway
between pads. Adjust by turning up the height of the lifting pads until they will reach the
manufacture indicated lifting points, if necessary use the needed lifting adaptors.
2. Lifting the vehicle
a. Switch on the main switch of the lift
b. Raise the vehicle by pressing of the push button „UP" until the vehicle is lifts of on a height
of 100-150mm.
c. Recheck to make sure the vehicle is secure and all locking pins are lock in place.
d. Always ensure safeties are engaged before any attempt is made to work on or near vehicle.
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2021-04
Manufacturer ATH-Heinl GmbH & CO.KG
- 9 -