GE JGP328 Instructions D'installation page 15

CHANGE COOKTOP BURNER
3
ORIFICES (CONT.)
Locate the LP/Propane orifices shipped
D
inside the literature package. They
will have a digit number and the letter
"L" on the side. (Important: Save the
orifices removed from the appliance
for future use.)
Each orifice will show a series of
engraved marks, (I, II, III, X or none),
located on the top.
These marks denote the precise location of
each orifice to the cooktop burner.
I II
18,000 BTU/HR Burner
The 18,000 BTU/HR burner has two orifices
with markings located in the sides only.
(See rating plate on bottom of appliance).
NOTE: The main orifice is located low in the
center of the burner while the simmer orifice
is located higher behind the center of the
burner.
Simmer
orifice
Installation Instructions
III X
(on some models)
Main orifice
Left Rear
Model Orifice
JGP328 II
JGP330 II
JGP933 III
JGP940 III
JGP945 III
E Install the LP/Propane orifices in
their precise locations as noted in the
illustrations above.
Return the natural gas orifices to the
F
bracket and reattach the bracket and the
instruction sheet to the pressure
regulator using the screw removed
previously.
Replace the burner bases, heads, caps
G
and top grates. (NOTE: When re-attaching
the burner bases to glass top units,
tighten screws to a maximum of
10 in.-lbs torque.)
15
Left Front Right Front
Orifice Orifice
II II
II III
II X
II X
II
Replace:
Main 206X N
Simmer 57N
With:
➔ 108X L
➔ 34L