Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
B
Using the appliance
Control panel
Switching on and adjusting the temperature
Insert the plug on the power cable into the earthed socket. The inside light comes on when the
refrigerator door is opened.
The temperature selection button is located on the left wall of the refrigerator compartment.
Positioning the button at "0" switches off the appliance.
Turn this button clockwise to activate the refrigeration unit, which will then operate automatically.
Setting "1" corresponds to the highest temperature and is the warmest possible setting. Setting
"7" (end-stop) corresponds to the lowest temperature and is the coldest possible setting.
WARNING!
We generally recommend that you select setting 5 ; if you
would like to obtain a higher or lower temperature, you
should position the button at a warmer or colder setting as
required.
WARNING!
• High ambient temperatures (e.g. hot summer days) and
a cold setting (position 6 to 7) can cause the compressor
to run continuously without interruption !
• Reason: when the ambient temperature is high, the
compressor has to run continuously in order to keep the
temperature low inside the appliance.
Getting started
Cleaning before use
Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm
water and a neutral soap to remove the characteristic odour of new products and dry thoroughly.
6
EN
B
Using the appliance
Installation
Installation and positioning
WARNING!
• Good ventilation must be maintained around the refrigerator
to allow for the dissipation of heat and high efficiency, and
sufficient space must be created around the refrigerator.
• We recommend leaving a 75 mm gap between the back
of the refrigerator and the wall and a minimum gap of 25
mm on both sides, a height of more than 100 mm from
the upper part and a space at the front so that the doors
can open 160°.
2
100 mm
100 mm
75 mm
The appliances must not be exposed to rain. Leave sufficient space around the lower rear part
of the appliance to allow air to circulate freely as poor air circulation can affect the performance
of the appliance. Integrated appliances should be positioned away from potential heat sources
such as radiators and sunlight.
Balancing
The appliance must be level in order to prevent vibration. To make sure that the appliance
is balanced, it should be positioned vertically and both adjustment feet should be in stable
contact with the ground. You can also adjust the level by loosening the corresponding front level
adjustment (with the fingers or a suitable spanner).
Electrical connection
WARNING
All electrical work required for the installation of this
appliance should be carried out by qualified or approved staff.
7
EN
Publicité
Table des Matières
