Sauder 416368 Mode D'emploi page 11

Step 8
Carefully stand your desk upright.
å
Insert the remaining PIVOT HINGE (25H) into the WASHER (9I) and into the DESK BOTTOM (E).
å
Insert the PIVOT HINGE, which is fastened to the DESK DOOR (I), into the hole in the DESK SHELF (G). You will need to tilt
å
your DOOR slightly.
Now, tip the DESK DOOR (I) in and fasten the free PIVOT HINGE (25H) to the DESK DOOR. Use a BROWN 7/16" LARGE
å
HEAD SCREW (6S).
NOTE: To make adjustments to the DESK DOOR, loosen the SCREW in the HINGE, make needed adjustments, and
å
tighten the SCREW.
Fasten the PULL (47K) to the DESK DOOR (I). Use two SILVER 3/4" MACHINE SCREWS (53S).
å
www.sauder.com/services
BROWN 7/16" LARGE HEAD SCREW
(1 used for the PIVOT HINGE)
G
E
25H
6S
9I
416368
47K
I
53S
SILVER 3/4" MACHINE SCREW
(2 used for the PULL)
Page 11