KBL megaSun Optima Mode D'emploi page 35

SERVICE
FIRMWARE-VERSIONS
> press enter
Submenu call with START/ENTER. Displays the cur-
rent fi rmware version of the system components.
Do not operate the system with different
fi rmware versions!
•
All system components must be equipped
with an identical
SERVICE
SOFTWARE UPLOAD
> press enter
Submenu call with START/ENTER. Displays the fi rst
and the last Software-Upload.
SERVICE
RGB-Setup
>
> 1
> 2
Only for devices with LED technology.
Colour adjustment of the LED decorative lighting.
Factory setting: 2
SERVICE
SERVICE MODE
> press ENTER
Submenu SERVICE MODE.
Invoked by pressing
START (ENTER).
Service mode without tanning
Service mode with tanning
All manuals and user guides at all-guides.com
04/10
fi rmware version.
05/10
06/10
07/10
SUBMENU
SERVICE MODE
SERVICE
Service mode without tanning
> Start: press `ENTER` for 2s
Troubleshooting mode.
The service mode is switched on for 30 minutes.
The mains voltage is connected. Error notifi cations
are ignored, but tanning cannot be started.
SERVICE
Service mode with tanning
> Start: press `ENTER` for 2s
Troubleshooting mode.
The service mode is switched on for 10 minutes.
The mains voltage is connected. Error notifi cations
are ignored, tanning can be started. After this pe-
riod, there is a 3 minute restart lockout.
SERVICE
SOLARIUM IDENTIFICATION
> press enter
Show the characteristics of the device:
- Confi guration code
- Variant code
- Serial number
SERVICE
SOLARIUM X-CODE
>
> PIN:
Branches to further confi guration options.
These settings must only be made by
trained service personnel!
U t i l i s a t i o n e t M a i n t e n a n c e |
01/02
02/02
08/10
09/10
35
Optima