AEG IDK84452IB Prescriptions De Montage Et Mode D'emploi page 63

USING THE EXTRACTOR FAN
Power-on
Press (touch) ON/OFF hob/ extractor
The indicator light will turn on to indicate that the hob/extractor is
ready for use
Press again to turn off
Note: This function has priority over the others.
Switching on the extractor fan:
Touch (press) the Selection bar (6) to activate the extractor fan
Extraction speed (power):
Touch and scroll along the Selection bar (6):
to the right to increase the speed (power) of the extractor fan (0-
10);
to the left to decrease the speed (power) of the extractor fan (10-
0);
Timer
Activation/Regulation of Timer function for the extractor
fan
•
Select the extractor fan (speed 0).
•
(8) to access the Timer function (from
Press
any speed)
•
Regulate the duration of the Timer:
press the selector
down time
press the selector
down time
the display (15) will show the countdown,
Note: on the side of the display of the extractor fan, with the Timer
in use, the following symbol will appear
When the timer has finished the countdown, there is an acoustic
signal (for 2 minutes, or it will stop when one of the buttons on the
hob is pressed), while the display (15) will flash, with the symbol
"
.
".
, to increase the automatic shut-
, to decrease the automatic shut-
(19)
To switch off the Timer:
•
select the cooking zone
•
set the value of the timer to " " , by means of
Not: the function remains active if no other key is pressed in
the meantime.
Filter saturation indicator
The hood indicates when filter maintenance is needed:
Grease filter
" "
the (17) LED lights up
Activated carbon odour filter
" "
the (17) LED flashes
Reset filter saturation
After carrying out maintenance on the filters (grease and/or
activated carbon) hold down the key
the " " (17) LED turns off and the count restarts.
Activation of activated carbon odour filter saturation
indicator
This indicator is normally deactivated.
To activate it, proceed as follows:
- turn on the aspiration hob by pressing
- with the aspiration motor and cooking zones off, press and
(7);
hold
" "
- turns on, then off to indicate successful
activation.
Deactivation of activated carbon odour filter saturation
indicator
repeat the activation steps described above
" "
flashes, then turns off to indicate successful
deactivation.
63
(7);
;